Error encountered while validating error encountered while ber decoding
26 The specified disk or diskette cannot be accessed. 30 The system cannot read from the specified device. If Windows still cannot find the network path, contact your network administrator. 62 Space to store the file waiting to be printed is not available on the server. 64 The specified network name is no longer available. 72 The specified printer or disk device has been paused. 136 The system tried to delete the JOIN of a drive that is not joined. 1017 The system has attempted to load or restore a file into the registry, but the specified file is not in a registry file format. 25 The drive cannot locate a specific area or track on the disk. 29 The system cannot write to the specified device. Verify that the network path is correct and the destination computer is not busy or turned off. 71 No more connections can be made to this remote computer at this time because there are already as many connections as the computer can accept. 135 An attempt was made to use a JOIN or SUBST command on a drive that has already been substituted. The registry could not read in, or write out, or flush, one of the files that contain the system's image of the registry.1080 Failure actions can only be set for Win32 services, not for drivers.1081 This service runs in the same process as the service control manager. 1113 No mapping for the Unicode character exists in the target multi-byte code page. 108 The disk is in use or locked by another process. 110 The system cannot open the device or file specified. 118 The verify-on-write switch parameter value is not correct. 122 The data area passed to a system call is too small. 132 The file pointer cannot be set on the specified device or file. 303 The file cannot be opened because it is in the process of being deleted. 996 Overlapped I/O event is not in a signaled state. 1012 The configuration registry key could not be read. 89 The system cannot start another process at this time. 101 The exclusive semaphore is owned by another process. 105 The previous ownership of this semaphore has ended. 107 The program stopped because an alternate diskette was not inserted. 117 The IOCTL call made by the application program is not correct. 131 An attempt was made to move the file pointer before the beginning of the file. 282 The mounted file system does not support extended attributes. 302 The volume is too fragmented to complete this operation. 536 Waiting for a process to open the other end of the pipe. 995 The I/O operation has been aborted because of either a thread exit or an application request. 1009 The configuration registry database is corrupt. 1011 The configuration registry key could not be opened.The table below describes these Error codes Code Description 0 The operation completed successfully. 150 System trace information was not specified in your CONFIG. 151 The number of specified semaphore events for Dos Mux Sem Wait is not correct. 157 The segment is already discarded and cannot be locked. 1058 The service cannot be started, either because it is disabled or because it has no enabled devices associated with it. 1060 The specified service does not exist as an installed service.
1103 A tape access reached the end of a set of files. 1107 Tape partition information could not be found when loading a tape. At least one other device that uses that IRQ was already opened.1076 The current boot has already been accepted for use as the last-known-good control set.